INFRARED ELECTRICAL INSPECTIONS

National Infrared Inspections of Electrical Inspections Detect system overloads, loose defective components and damaged switchgear. Infrared electrical testing finds hot, dangerous problems quickly.

Infrared electrical inspections find hot spots caused by defects in connections and components. Infrared thermography is used to find areas of excess heat (caused by increased resistance) so that problems can be corrected before a component fails, causing damage to the component, creating safety hazards and productivity loss.

Because increased heating is a sign of failure, infrared is the best diagnostic tool available for finding these hot connections in the early stages of degeneration. This is why your insurance company may have asked for an electrical infrared inspection, to find and prevent problems before they cause damage to your personnel, equipment and facility.

National Infrared Inspections of electrical switchgear including but not limited to;

  • Electrical & Mechanical Services Switchboards
  • Motor Control Centres
  • Control Consoles
  • Transformers
  • Power Factor Correction Units
  • Tee Off Boxes
  • Tenant Meter Panels
  • Service Fuses
  • Pyrotenax Cable Joints
  • Motor Bearings & Gear Boxes
  • Defects Liability Acceptance Reports
  • Condition Monitoring
  • Preventative Maintenance Plans
  • Issuing Certificates of Compliance
  • Asset Register Reports
  • Electrical & Mechanical Audits
  • Insurance Audits

Conditions Detectable by an Infrared Inspection

  • Loose connections
  • Deteriorated connections
  • Overloads
  • Open circuits
  • Unbalanced loads
  • Inductive heating
  • Harmonics
  • Defective equipment

“Save Money on Your Energy Bill Today!”

0411 815 359